Emit.redefinition has taken ~debug since it was written and was tested
with it; Session.eval never passed it, so every body installed by C-c C-c
lost its debug info in the running process.
Passing it alone would have been half a fix. Build.shared is what forces
-O0, and dev.ml built modules at -O2, so the llvm.dbg.declares would have
been emitted and then deleted by mem2reg: a line table, and no locals.
And a module with DWARF loaded into a host without it lines up against
nothing. So it is one flag — flan dev --debug and flan reload --debug —
and it sets the host build, the module builds and the emitted metadata
together. Off by default: a debug build is an -O0 build, and quietly
making every reloaded body -O0 changes the frame time of the one function
you are iterating on, in the loop whose point is watching that number.
What a dlopen'd module does to a breakpoint, measured against the reload
fixture rather than reasoned about:
- lldb reads the new module's DWARF on the dlopen and says so: "1
location added to breakpoint 3".
- A breakpoint set by NAME gains a second location either way, so
dlopen was never the difficulty. What the line table buys is that it
stops with source instead of disassembly.
- A FILE AND LINE breakpoint on the new body resolves only with it;
without, it sits at locations = 0 (pending) forever.
- A FILE AND LINE breakpoint on the HOST's copy stays pinned at
locations = 1. That is correct, not stale: the old body is still
mapped and every call site that has not gone through its cell again
still reaches it.
- The stack crosses intact — a frame in the reloaded .so and the one
below it in the host each name their own .flan file.
(lldb) frame variable
(long) step = 10
(long) prior = 11
The transcripts are in flan-dape.el, replacing the note that said the
module carries no DWARF yet.
flan-cnr.el's stack pane was refusing for the wrong reason. DWARF was
never its gap; nothing is attached to the stopped program, and a socket
cannot read another process's frames. Reworded to say that.
Source interleaving in the disassembly buffer is unblocked and not done:
objdump -dS interleaves a --debug module's Flan source correctly, so
Dev.asm_of needs the -S and a parse_listing that tolerates source lines.
Joseph Ferano
d0a8339bb5